Micromilling of thin ribs with high aspect ratios
article
Micro features with high aspect ratios are one of the commonly encountered geometries found in micro products. In the literature, these structures are often used in demonstrator products machined by a micromilling process. In this paper, the challenges in micromilling thin ribs with high aspect ratios have been studied. Due to the scaling effect, micro-ribs have relatively low stiffness but high natural frequency. Therefore, on the one hand, average forces have to be controlled well to avoid structural bending or even damage, while on the other hand, micro features are unlikely to be excited by the dynamic forces. The characteristics of micromilling forces and their relationships to the machining parameters, namely, feed per tooth, depth of cut and width of cut, were studied theoretically by force models. In addition, the effects of different milling strategies (up-/down-milling) and tool paths on the quality of thin features have been investigated using FEM. The results allow measures to be taken to minimize the force effects and support the micro features during machining. The experimental results verify the theoretical studies. Thin ribs about 15 μm wide and with an aspect ratio of more than 50 were machined with good form and surface quality. © 2010 IOP Publishing Ltd Pr.
TNO Identifier
425701
ISSN
09601317
Source
Journal of Micromechanics and Microengineering, 20(11)
Article nr.
No.: 115013