Development of propellant compositions for vat photopolymerization additive manufacturing

A photocurable energetic resin was developed for photopolymerization additive manufacturing. The composition contains 50 wt % RDX, 25 wt % acrylate binder, and 25 wt % energetic plasticizer. The material was characterized in terms of compatibility, printability, mechanical properties and (ballistic) performance. The possibility of printing...

Poly(caprolactone -co -trimethylenecarbonate) urethane acrylate resins for digital light processing of bioresorbable tissue engineering implants

To exploit the usability of Digital Light Processing (DLP) in regenerative medicine, biodegradable, mechanically customizable and well-defined polyester urethane acrylate resins were synthesized based on poly(caprolactone-co-trimethlenecarbonate). By controlling the monomer ratio, the resultant fabricated constructs showed tunable mechanical...

Effect of materials properties in 3D product geometry during stereolithography

Printed electronic switch on flexible substrates using printed microcapsules

Printed electronics, the manufacturing of electronic components on large, flexible, and low-cost substrates by printing techniques, can facilitate widespread, very low-cost electronics for consumer applications and disposable devices. New technologies are needed to create functional components in this field. This paper introduces a new method to...

Temperature-triggered release of a liquid cross-linker micro-encapsulated in a glassy polymer for low temperature curing

In order to prevent a liquid epoxy cross-linker from premature, Arrhenius-law predicted, reaction with an acid-functional polyester resin, the liquid cross-linker has been physically separated from the resin by encapsulation while release is only possible by a temperature-controlled trigger. The glass transition temperature Tg of the polymeric...

Development and evaluation of a biocide release system for prolonged antifungal activity in finishing materials

This paper focuses on the use of modified nano-clay particles as a controlled release system for biocides from building materials. Different (model) biocides were incorporated in a biocide/nano-clay composite and subsequently the release of the biocides was monitored under different environmental conditions. In addition, the biocide/clay...

Additive manufacturing approaches for stress relief in semiconductor die packaging

Packaging of semiconductor chips, especially MEMS-based, always causes stress on the functional areas of the die causing unpredictable changes in chip performance. As a consequence such devices can only be calibrated individually after complete assembly. Melexis and TNO have developed an approach to reduce significantly packaging stress effects...

Temperature-induced hybrid hydrogels as a scaffold for nucleus pulposus replacement

Novel encapsulation technology for the preparation of core-shell microparticles

High density hydrophilic and hydrophobic brush coatings using a polymeric primer layer

Polymer brush coatings, consisting of polymer chains covalently attached to a surface and being less than a hundred nanometer thick, allow the creation of functional surfaces without altering the inherent bulk properties or appearance of a product. Surface properties depend on the type and length of the polymer used, as well as on the grafting...