Feasibility of 4 GHz half wavelength contact acoustic microscopy (HaWaCAM)
van Neer, P.L.M.J.
van Es, M.H.
van Riel, M.C.J.M.
Several methods are being researched to detect and characterize buried nanoscale structures in hard solid samples. The most common acoustic method is acoustic microscopy. An acoustic microscope is based on a single element transducer operating in pulse-echo mode. The acoustic waves are coupled into a sample using a liquid couplant (eg water) and the beam is focused using a geometric lens to obtain a good lateral resolution. Thus, the frequency is limited by the attenuation in the coupling layer (water: ~3.5 dB/µm at 4 GHz) and the typically low transmission coefficients at the transducer-liquid couplant and liquid-sample interfaces. Here, we present a novel method for high frequency acoustic metrology of buried structures in solid samples. The concept consisted of a 4 GHz acoustic transducer integrated above the tip of a custom designed probe. It operated in pulse-echo mode, and used solid-solid contact with the sample without the need for liquid coupling layers. A prototype was built and successfully tested experimentally on samples consisting of silicon with 1D and 2D arrays of µm sized features buried below 5 – 10 µm of PMMA or SiO2 top layers. Moreover, a good match was obtained between model predictions and measurements of the pulse-echo performance of the novel GHz acoustic metrology method. The technique features a penetration depth of O(10s of μm), is nondamaging and is not hampered by optically opaque layers.
GHz acoustic metrology
To reference this document use:
Half wavelength contact area
Half-wavelength contact acoustic microscopy
High Tech Systems & Materials
IEEE, Piscataway, NJ, USA
2021 IEEE International Ultrasonics Symposium, IUS, September 2021, Virtual