Title
Bending-shear interaction of steel I-shaped cross-sections. Statistical investigation
Author
Dekker, R.W.A.
Snijder, H.H.
Maljaars, J.
Publication year
2017
Abstract
Clause 6.2 of EN 1993-1-1 covers the cross-sectional resistance of steel sections. The bending-shear interaction design rules for I-shaped cross-sections make use of a reduced yield stress for the web area. On this basis, a reduced design plastic resistance moment allowing for the shear force is presented. The effect of shear on the bending resistance may be neglected if the shear force is less than half of the plastic shear resistance of the cross-section. Plasticity in the Eurocode is described by the well-known Von-Mises yield criterion, however, the formula used for the reduced yield stress deviates from this criterion, resulting in sometimes greater and sometimes smaller values. The background of the Eurocode formula for reduced yield stress can be found in a publication by Drucker. The purpose of the present research is to investigate the influence of shear on the bending resistance of I-shaped steel cross-sections with as result a possible reconsideration of the Eurocode design rules. At Eindhoven University of Technology an experimental investigation on bending-shear interaction in rolled steel I-shaped sections was performed. A numerical model was developed in Abaqus Finite Element software to simulate the experiments. With the validated numerical model a larger database of numerical ‘test’ results was generated, which was subsequently used in a statistical analysis following Annex D of EN 1990 as further developed in the RFCS project Safebrictile. The statistical distributions of the steel properties recommended by Safebrictile were adopted. This paper presents the results of the statistical analysis and safety assessment of the strong axis bending-shear interaction design rule currently present in Eurocode 3. The parametric test group consists of HEA, HEM and IPE sections in the steel grades S235, S355 and S460: in total 180 numerical simulations with increasing amount of shear. A stress-strain model including strain hardening was used in the numerical simulations, since the influence of strain hardening is also largely present in the experimental test program. Based on strain hardening material behavior it is show in this paper that the current partial factor is un-conservative for shear dominated beams and should be increased. Alternatively, the design rule should be modified.
Subject
2015 Fluid & Solid Mechanics
SR - Structural Reliability
TS - Technical Sciences
Buildings and Infrastructures
Architecture and Building
2015 Urbanisation
Statistical evaluation
Cross-sectional resistance
Bending-shear interaction
I-section
To reference this document use:
http://resolver.tudelft.nl/uuid:ec81d75f-9835-481b-9e48-cbbf81fad44a
TNO identifier
783115
Source
Eurosteel 2017, September 13-15, 2017, Copenhagen, Denmark, 3699-3708
Document type
conference paper